Cata HGR 110 AS WH - Manual (Page 40)

ELECTRICAL CONNECTION
Before connecting the appliance, check that the voltage
marked on the specifications plate coincides with the volta-
ge of the electricity network.
The NICEIC register is recommended for electrical installa-
tions.
WARNING – THIS APPLIANCE MUST BE EARTHED
This appliance must be wired to a 13 A bipolar automatic
switch with protected socket, which has a 3 mm separation
between contacts and is placed in an easily accessible pla-
ce next to the appliance.
IMPORTANT
The conductors of the network power supply lead are co-
ded by colours are follows:
Green and yellow -Earth
Blue - Neutral
Brown - Live
• The green and yellow conductor must be connected to
the terminal marked “E” or with the symbol of the earth or
which is green and yellow.
• The blue conductor must be connected to the terminal
marked “N”.
• The brown conductor must be connected to the terminal
marked “L”.
• The lead must not reach a temperature higher than 50 ºC
above the ambient temperature at any point.
• If the power lead is damaged, it must be replaced by a
special lead or unit supplied by the manufacturer or it after-
sales service.
REPLACEMENT OF THE NETWORK POWER SUPPLY LEAD
If it is necessary to replace the network power supply lead,
proceed as follows:
1. Disconnect the appliance from the power supply, uns-
crews the fastening screws and remove the rear panel.
2. Unscrew the fastening screws and those of the terminals
to free the existing lead.
3. Assemble the replacement lead which must comply with
the information listed in the Specifications, ensuring the co-
rrect connection of the colour codes and that all the screws
are correctly tightened.
MAINTENANCE
Before carrying out maintenance, disconnect the appliance
from the power supply.
During the guarantee period, if necessary all services
should be commissioned to the Manufacturer’s Technical
Assistance Service Department. Bear in mind that interven-
tion or repair by unauthorised personnel will invalidate this
guarantee.
REPLACEMENT OF THE OVEN LIGHTBULB
(Not covered by the appliance guarantee.)
The oven has a light with the following characteristics: 15 W
or 25 W, 300 ºC and type E-14
WARNING: Disconnect the appliance from the electricity
supply, remove the oven door (as described above), as well
as the oven shelves.
Remove the glass cover that protects the light bulb by tur-
ning it anti-clockwise. Fig. 9 (A)
Unscrew the old light bulb and dispose of it safely and eco-
logically, change it for one as specified in the Specifications
and replace the cover.
NOTE – The glass cover may be tight and, therefore, may
need a grip to release it.
CARE AND REPLACEMENT OF THE CATALYTIC COVERING
(When assembled, the covering is not covered by the
appliance guarantee).
In order to keep the covering “always clean” efficiently,
the oven must be heated to a minimum of 200 ºC whene-
ver there are stubborn stains, so that they do not become
permanent.
If the covering becomes black and shiny, they must be re-
placed. Remove all the internal accessories to facilitate the
replacement of the covering.
The replacement covering may be bought directly from the
Manufacturer’s Replacement Part Department (see details
included in the cover). Indicate the reference numbers of
the product type described in the specifications plate and/
or the series number of the appliance on ordering.