Configuration:save, Configuration:recall, 9 configuration:interface:tx coding format – Comtech EF Data SDM-2020 User Manual
Page 59: 3 configuration:save, 4 configuration:recall
SDM-2020 Satellite Modulator
Revision 7
Front Panel Operation
MN/SDM2020M.IOM
5-17
5.6.2.9
CONFIGURATION:INTERFACE:TX CODING FORMAT
TX CODING FORMAT
AMI
Note: Available with G.703 interface installed.
Use this menu to program the TX coding format for one of these choices:
• AMI
• B8ZS
• HDB3
• B3ZS
On entry, the current status is TX Coding Format displayed.
1
Press [
↑] or [↓] to select ON or OFF.
2
Press <ENTER> to execute the change.
5.6.3
CONFIGURATION:SAVE
CONFIGURATION #X
SAVE
Use the Configuration Save menu to program configuration parameters into memory on
the M&C. There are 10 memory locations that may be used to store specific frequently
used configuration setups.
1
Change the configuration parameters to the desired settings.
2
Enter the Configuration Save menu.
3
Press [
↑] or [↓] to select a memory location (range = 1 through 10).
4
Press <ENTER> to execute the save.
5.6.4
CONFIGURATION:RECALL
CONFIGURATION #X
RECALL
Use the Configuration Recall menu to recall a previously saved configuration setup.
1
Press [
↑] or [↓] to select a memory location (range = 1 through 10).
2
Press <ENTER> to execute the recall.