7 function select:utility:asi/lvds – Comtech EF Data SDM-2020 User Manual
Page 81
SDM-2020 Satellite Modulator
Revision 7
Front Panel Operation
MN/SDM2020M.IOM
5-39
5.6.8.7
FUNCTION SELECT:UTILITY:ASI/LVDS
INTERFACE TYPE
ASI/LVDS
This status-only item displays ASI/LVDS or UNKNOWN. No changes can be made from
this menu. Use [
↑] or [↓]to select an interface type and press <ENTER>.
INTERFACE SELECT
ASI
Note: LVDS cannot be selected if jumper position is in RX_LVDS mode.
This display shows the mode type ASI or LVDS interface. Upon entry, the current status
of the mode type is displayed.
1
Press [
↑] or [↓] to select an item.
2
Press <ENTER> to execute the change.
TX INTF FIRMWARE
FW/XXXX
Press <ENTER> to show the FW Release date.
TX INTF FIRMWARE
MM/DD/YY
Press CLEAR to exit the data menu.
ASI LINK SELECT
B-LINK (J3)
Note:
This is for ASI mode only.
This display shows the A-LINK (J4) or B-LINK (J3). Upon entry, the current status of the
mode type is displayed.
1
Press [
↑] or [↓] to select an item.
2
Press <ENTER> to execute the change.