COWON SP2 - Manual (Page 8)

COWON SP2 25
- The screen of a mobile phone must be in unlocked mode during pairing
via NFC.
- The NFC chip of a mobile phone and SP2 must be in 1 centimeter during
pairing.
- The pairing procedures are subject to different models of mobile phones.
Please refer to the user manual of your mobile phone for further information.
- Please refer to 'Pairing SP2 with Bluetooth Mobile Phone via Bluetooth'
below when mobile phones are not NFC enabled.
■ Pairing SP2 with Bluetooth mobile phone via Bluetooth
1. Make SP2 enter pairing mode.
(please refer to 'How to enter pairing mode').
2. Activate your mobile phone’ s Bluetooth function and set your mobile phone
to search for Bluetooth devices within range. Select 'COWON SP2' from the list
of devices.
3. Enter a password or a PIN No. '0000' following the instruction.
4. If prompted by your mobile phone to connect, select 'Yes'.
5. After successful pairing, choose and connect 'SP2' from the list of devices
shown on a mobile phone.
6. After successful connecting, blue LED of SP2 will flash twice every 4 seconds .
- Keep SP2 and a mobile phone within 1 meter when pairing.
- If the mobile phone supports Bluetooth V2.1, password is not required.
- If pairing is failed, please turn off SP2 first and re-pair following steps 1~6
mentioned above
- After successful pairing, SP2 and the mobile phone will remember each
other. They do not need to re-pair next time. The speaker can remember
8 paired devices. When the number of paired devices exceeds 8, the first
one will be replaced.
- Every time when SP2 is turned on, it will connect to a last connected device
automatically. If you want to pair it with other devices, please turn off the
Bluetooth function of the last connected device first and pair the speaker with
the new device following steps 1~6 mentioned above.
■ Pairing SP2 with Bluetooth transmitter via Bluetooth
1. Make SP2 enter pairing mode.
(Please refer to 'How to enter pairing mode').
2. Turn on the Bluetooth transmitter and make it enter pairing mode. It will search
for Bluetooth devices automatically and send a pairing request.
Using This Product
+ Pairing and Connecting with Mobile Phone