D.T. Systems H2O 1810 PLUS - Manual (Page 15)

15
TESTING
To Test the Beeper:
(H
2
O 1850 PLUS only)
A) Press the button located on the left side of the
transmitter (Locate button). The collar will beep
any time this button is pressed.
B) Press the button on the right side of the transmitter
(Run/Point button) to activate the Run & Point
mode. Press the button again to change to Point
Only mode. In the Run & Point mode, the collar
will beep every 4-5 seconds while shaking the
collar unit (simulating a dog on the run), and every
1-2 seconds when keeping the collar unit
motionless (simulating your dog on point). In the
Point only mode, the collar will beep only when the
collar unit remains motionless.
C) Press the ’Locate’ button to cancel these modes.
To Test the Rise:
(H
2
O 1830 PLUS only)
A) The Rise feature will gradually increase the inten-
sity level starting from the level set on your dial.
To see a greater range of intensity change, set the
intensity dial to a lower level.
B) Press and hold the button on the right side of the
transmitter (Rise button) and the test light will get
brighter as the button is held.
NOTE: If the collar unit is not responding to any signals from
the transmitter, the collar may need to be reprogrammed to
the transmitter (see page 16).