D.T. Systems H2O 1810 PLUS - Manual (Page 16)

16
PROGRAMMING THE COLLAR
When adding an “Add-On” collar, the collar will need
to be programmed to the transmitter. If your current
collar unit is not responding to the transmitter, it may
also need to be reprogrammed to the transmitter.
1. Select the desired Collar Selecting Switch position
on the transmitter.
2. Press and hold the power button on the collar like
the collar unit is being turned ON.
3. A small red light inside the Collar Receiver will
light up solid for about 1 second, followed by sev-
eral flashes. Do not let go of the button during this
step.
4. Continue to hold the button until the LED light
stays on solid. The Collar Receiver is now in the
Code Running Mode (the LED light will stay lit for
approximately 8 seconds while it is in this mode).
5. Release the Collar Receiver button and press the
NICK and CONT buttons simultaneously while it is
in the Code Running Mode.
6. When the LED light blinks 3 times, the Collar ID is
programmed and the Collar Receiver is now ON.
NOTE – Do not release the button on the Collar
Receiver until after the LED light stops flashing
and stays on solid or the Collar Receiver will not
go into the Code Running Mode. The NICK and
CONT buttons must be pressed simultaneously
while the LED light is lit solid or the Collar Re-
ceiver will not be programmed.