D.T. Systems H2O 1810 PLUS - Manual (Page 17)

17
PROPERLY FITTING THE COLLAR
NOTE: Proper collar tightness and
position are very important to insure
safe and consistent collar use.
All electronic collars need to be
very snug around the dog’s neck
to work properly. They must be
just tight enough to allow the
“contacts” or electrodes to make
good contact on your dog’s skin.
If the collar is too loose, the
stimulation may not work properly because good/
consistent skin contact is not being achieved. This
can directly affect the performance of the collar unit
and whether or not the dog will receive the stimulation.
Always check for good contact to the skin if it appears
that your dog is not responding to the stimulation. A
loose collar can also result in skin irritations from
moving or rubbing too much against your dog’s neck
while they are running or training. A proper fit will help
prevent this from occurring.
•
Place the collar unit high and tight on your dog’s
neck with the collar receiver box centered below the
neck. Placing it at the wider base of the neck can
let it travel up to the narrower part of the neck while
your dog is moving, loosening as it goes.
•
It should be tight enough to fit two fingers between
the collar belt and your dog’s neck, but not tight
enough to restrict your dog’s breathing.