Master/echo connection – Daktronics AB-1010 User Manual
Page 23
Electrical Installation
3-7
3.8 Master/Echo
Connection
ng:
”, 30” and 36”
...
....................
...Dr
Diag
S422 Inca
n
ys............
.. Dr
Reference Drawi
Schematic, Sunspot 24
.......... ............
..........
awing B-141704
System Riser
ram, R
ndesce t Displa
..........
awing A-148859
System Riser Diagram, RS232 Incandescent Displays........................ Drawing A-148870
..... Drawing A-148878
Drawing A-148884
For
ignal is then sent from the master display’s signal junction box to the echo’s corresponding signal
gauge, shielded wire.
rs & Optional Temperature Sensors Electrical Connection
System Riser Diagram; Fiber Incandescent Displays .....................
System Riser Diagram; Modem Incandescent Displays.......................
a master/echo display system, signal is hooked up to the master display according to Section 3
S
junction box with 22-
3.9
Light Detecto
efer to Appendix B for information on installing the light sensor.
R
If your display has an optional temperature sensor, refer to Appendix B for information on electrical
installation.