Daktronics AB-1010 - Manual (Page 8)

Figure 1: Drawing Label
Introduction 1-2
All references to drawing numbers, appendices, figures or other manuals are presented in bold
typeface, as shown below.
“Refer to Drawing A-114667 for the location of the panel board.”
In addition, any drawings referenced within a particular sub-section are listed at the beginning of that
sub-section in the following manner:
Reference Drawing:
Shop Drawing; 16 High 2 ½” Small Matrix .......................................... Drawing A-114667
Referenced drawings are found in the Appendix A.
Daktronics identifies manuals by an ED number located on the cover page of each manual. Its ED
number will identify any manuals referenced in this manual. For example, this manual would be
referred to as ED-12161.
The serial number and model numbers can be found on the ID label, located on the display. This label
will look similar to the one shown in Figure 2. When calling Daktronics Customer Service, please
have this information available to ensure that your request is serviced as quickly as possible.
Daktronics displays are built for long life and require little maintenance. However, from time to time,
certain display components will need replacing. The Replacement Parts List in Section 4 provides the
names and part numbers of components that may need to be ordered during the life of this display.
Following the Replacement Parts List in Section 4 is the Exchange/Replacement Procedure. Refer to
these instructions if any display component needs to be replaced or repaired.
1.2 Daktronics Nomenclature
To fully understand some Daktronics drawings, such as schematics, it is necessary to know how
various components are labeled in those drawings. You will find this information useful when trying
to communicate maintenance or troubleshooting efforts.
Figure 2: Display ID Label