DFI KS210-IMX6 Manual - Manual (Page 10)

www.dfi .com
10
Chapter 2 Installing the Devices
Chapter 2
Chapter 2 - Installing the Devices
Connecting the Cable to the Terminal Block
1. Insert the cable end of the power adapter to the terminal block. To firmly fix the cable into
the terminal block, use a screwdriver to clamp down the wires to the screw that is in the
terminal block .
2. Plug the terminal block into the DC-in connector and then tighten the screws to secure the
terminal block in place.
Terminal block
Wire
Power adapter cable
DC-in
connector
Screws
White Wire Black Wire
+ -
Note:
The system unit used in the following illustrations may not resemble the actual one.
These illustrations are for reference only.