DFI EC300 Series - Manual (Page 126)

126
7
BIOS Setup
If AHCI or RAID is selected in the SATA Mode Selection, it will display the
following information:
Serial ATA Port 0 to Serial ATA Port 3
These fi elds are used to confi gure the connected SATA devices.
Aggressive LPM Support
Enter PCH to aggressively enter link power state.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Advanced
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
SATA Controller(s)
SATA Mode Selection
SATA Test Mode
Agressive LPM Support
 Software Feature Mask Confi guration
Serial ATA Port 0
Software Preserve
Port 0
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 1
Software Preserve
Port 1
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 2
Software Preserve
Port 2
Hot Plug
External SATA
Spin Up Device
Serial ATA Port 3
Software Preserve
Port 3
Hot Plug
External SATA
Spin Up Device
[Enabled]
[AHCI]
[Disabled]
[Enabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
[Disabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
[Disabled]
Determines how SATA
controller(s) operate.

