Digi-Star EZ4300 - Manual (Page 20)

EZ 4300
16
Rotation Counter
Press [Timer/Counter].
Use the numeric keypad to enter the number of rotations.
Press [Timer/Counter].
The Rotation Counter will begin to count down, when the counter has reached
zero, the alarm light and buzzer will turn on.
Press [Clear] to turn off the alarm and enter the weighing mode.
Press [Recipe] or [Pens] to re-enter the batching mode.
Drive Ratio
The drive ratio is the ratio of the number of turns seen by the sensor divided by
the number of mixer rotations.
Example: The sensor for the rotation counter is on a PTO. Every 30 rotations of
the PTO the counter will count 1 rotation. Enter a value of 30.00.
Example: The sensor for the rotation counter is on a bearing end. The shaft
makes 2-1/2 rotations for each rotation of the mixer. Enter a value of 2.50.
Enter short cut number “422” and press [Select].
Use the numeric keypad to enter the value.
Press [On] to store the setting.
Scale ID or Truck ID
Each EZ4300 has a scale ID name. To change the scale ID name or number:
Enter short cut number 108 and press [Select].
Press [Clear] to erase the old ID name or number.
Use the alphanumeric keypad to enter the new ID name or number.
Press [On] to store the setting.
Note: If you are using the scale with a software program, i.e. TMR Tracker or Diet
Manager, make sure the ID matches what is entered in the software program.
Radio Number
Enter short cut number “231” and press [Select].
Press [Select] to change the radio number.
Press [On] to store the setting.
Note: Do not use the same number for two different scales.