ETA Ambo - Manual (Page 32)

Place a suitable container under the mill to collect the ground poppy seeds. Start up
the drive unit. We recommend that you first check a small sample of poppy seeds on
graininess upon their processing (i.e. grinding). If the graininess of ground poppy seeds
is not optimal, switch off the drive unit and then adjust the setting by regulating disc S5
(i.e. by turning anti–clockwise = coarser grinding, by turning clockwise = finer grinding).
If the graininess of the processed sample is now ideal, complete the grinding process
on the remaining amount of seeds. In case that you need to process a higher amount of
poppy seeds, make sure not to exceed the maximum operating time of the drive unit.
Recommendation
– Ensure good quality of poppy seeds. We recommend that you check poppy seeds for
presence of any foreign objects before milling (e.g. fragments of stones) which could
damage the product (e.g. abrade the grinding discs). Possible complaints within the
warranty period as a result of these impurities will not be taken into account.
– Use only dry poppy seeds when milling! Poppy seeds must be ground, not pressed,
so that they stay loose, do not pulp and do not lose their distinctive flavour.
– Poppy seeds contain oil. To ensure good grinding results, do not set a very fine degree
of grinding.
– Preparation (processing) time ranges in units of minutes, depends on the quantity,
type and quality of used poppy seeds and on the set fineness of grinding (ca. 150 g / 2
minutes).
– When grinding a “higher” amount of poppy seeds, the parts of the extra attachment can
get hot (e.g. the grinding discs, pusher plate, carrier). Wait a moment before disassembly
and cleaning. Be careful not to get burnt.
IV. MAINTENANCE
Unplug the power cable from socket before any handling with the appliance! Do not
use rough and aggressive cleaning agents! Perform any cleaning of the drive unit and
the carrier only with wet rag with detergent. Wash other accessories immediately after
use in hot water with detergent. Work very carefully when cleaning the knife! Note that
cutting edges of the knife and grinding discs shall not come into contact with hard objects
which blunt them and decrease their efficiency. After washing and drying the parts, we
recommend to lubricate the knife, grinding discs, pusher plate and plates with table oil.
Metal parts must not be washed in the dishwasher because cleaning agents can cause
their darkening or rusting. Some agents can tinge the accessories in some way. However,
this has no influence on function of the appliance and this tint usually disappears by itself
after some time. Never dry plastic mouldings above heat sources (e.g. stove, electric
cooker, gas cooker).
Wind up the power cable A1 on the holder in the base of the appliance. Store the
appliance on dry and dust–free place out of reach of children and incapable persons.
Procedure for replacement of broken tooth wheel
Remove the spiral feeder F. Loosen the bolt using an appropriate tool (screw driver).
Remove the tooth wheel F1 from the spiral feeder. Put new tooth wheel on the axe of the
spiral feeder and tighten it properly with the bolt (Fig. 9).
32
GB
/ 53