Flowserve SMB Series Electric Actuators - Manual (Page 9)

9
SMB Series/SB Series Installation and Maintenance FCD LMENIM1401-04-AQ – 01/15
flowserve.com
2.3 Inspection and Recording
Upon receipt of the actuator:
1. Carefully remove the actuator from the shipping carton or skid. Thoroughly examine the equip-
ment for any physical damage that may have occurred during shipment. If damaged, immediately
report the damage to the transport company.
2. A nameplate is attached to each actuator. Record this information for future reference, i.e.
ordering parts or obtaining further information.
2.4 Storage Procedure
NOTE: The following is our recommended storage procedure to retain maximum product integrity
during storage. Failure to comply with recommended procedures will void the warranty. For longer-
term storage, contact Limitorque for procedures and recommendations.
Storage (less than 1 year)
Actuators are not weatherproof until properly installed on the valve or prepared for storage.
Store actuators in a clean, dry, protected warehouse, away from excessive vibration and rapid
temperature changes. If the actuators must be stored outside, they must be stored off the ground,
high enough to prevent them from being immersed in water or buried by snow.
1. Position the actuator in storage with motor and switch compartment horizontal.
2. Connect the internal heaters (if supplied) or place desiccant in the switch compartment.
3. Replace all plastic caps or plugs with metal pipe plugs and ensure that all cover bolts are tight.
4. If the actuator is mounted on a valve and the stem protrudes from the actuator, a suitable stem
cover must be provided.