GAI-Tronics CommandPLUS Series Desktop Console Installation and Service Manual - Manual (Page 33)

CommandPLUS Series Desktop Console Installation and Service Manual Console Diagnostics
29 12/10
Setting the Clock
The clock can be adjusted by selecting the Set Clock and Date menu. When selected, the following
display is shown.
SET CLOCK/DATE
HH:MM:SS PM MM-DD-YY
<SCROLL> TO SELECT
<MODE> TO EXIT
<1-9> TO SET VALUE <TRANSMIT> TO SET
12:22:19PM VU
MAY-12-07
Figure 12. Set Clock and Date Menu
The hours field of the displayed time flashes to indicate that the clock can be set to the correct hour. To
alter the flashing value, enter the desired value directly from the keypad. After the two digits have been
entered to set the hour, the minutes field begins flashing indicating that the minutes should now be
entered. This continues through the seconds, month, day and year fields. After the seconds field has
been entered, AM or PM must be selected using 1 for AM or 2 for PM.
The SCROLL Up or Down button can be used to move between the different fields without entering a
new value. To advance to the next field without altering the value that is currently flashing, press the
SCROLL Up button. To the previous field without altering the value that is flashing, press the SCROLL
Down button.
When the correct time and date appear in the display, press the TRANSMIT button to set the time and date
and exit the Set Clock/Date menu.
Setting the Display Viewing Angle
The console is normally viewed from a particular angle. Adjust the display so that it appears sharpest at
this angle. To perform this adjustment, press 2 from the Clock and Display Set menu. The screen shown
below is displayed.
ADJUST DISPLAY VIEWING ANGLE
VIEWING ANGLE = 5
<SCROLL UP/DOWN> TO INCREASE/DECREASE
<0-7> TO SET VALUE <MODE> TO EXIT
12:22:19PM VU
MAY-12-07
Figure 13. Viewing Angle Adjust Menu
To adjust the viewing angle from this screen, use the SCROLL Up/Down buttons or enter a value from 0
through 7 directly from the numeric keypad. Continue to adjust the viewing angle until the display
appears sharpest when looking at it from your normal work position. Press the
MODE button to save the
displayed viewing angle and return to the Clock and Display Set menu.