GAI-Tronics CommandPLUS Series Desktop Console Installation and Service Manual - Manual (Page 42)

Features and Options CommandPLUS Series Desktop Console Installation and Service Manual
12/10 38
DC Control CP0010A/XCP0010A
This option provides standard dc control currents on a per channel basis. Its operation requires the
installation of one option card for each dc-controlled channel.
Installation/Relocation
IMPORTANT: OBSERVE STATIC CONTROL PROCEDURES
1. Disconnect power from the CommandPLUS Series Desktop Console.
2. Remove the seven screws securing the top panel and gently lift the cover exposing the attached
speaker cable and master display cable. See Figure 16 below.
3. Disconnect the speaker cable at the male-to-female connection point. Unplug the master display
cable from the top cover. Also unplug the ESD ground wire from the front panel quick-disconnect
lug.
4. Disconnect all plugs attached to the inner slave board mounting plate. See Figure 16. Then remove
the four screws attaching the mounting plate to the base. This allows you to remove the mounting
plate.
Figure 16.