Guralp Systems CMG-DCM build <10,000 - Manual (Page 116)

Acquisition Modules and Platinum Firmware Digitiser Configuration
­­ids sys ser ― Specify new system ID and serial number to set
following a hard factory reset. This option will attempt to preserve the
previous values if new values are not specified)
­­samp # # # # ― Change the sample speeds for each of the four
decimation taps. This option requires four numeric values as supplied for the
SAMPLES/SEC command described in the DM24 manual.
­­cont # # # # ― Change which streams are produced as continuous
output from each of the decimation taps. This option requires four numeric
values as supplied for the CONTINUOUS command described in the DM24
manual.
­­trig # # # # ― Change which streams are produced as triggered output
from each of the decimation taps. This option requires four numeric values as
supplied for the TRIGGERED command described in the DM24 manual.
­­gps­baud # ― Set the line speed for the GPS port. This option requires a
single numeric value: the new line speed to use.
­­in­baud # ― Set the line speed for the DATA IN port. This option
requires a single numeric value: the new line speed to use.
­­upgrade ― Upgrade firmware files only (this is the default).
­­downgrade ― Allow firmware files to be downgraded as well as
upgraded.
­­force ― Firmware files are to be loaded even if they appear identical, or
the installed version number cannot be decoded.
­­boot file ― Specify a source file for DM24mk3 bootstrap. This option
requires a single value, file, which is the path to the firmware image file to
be loaded.
­­firm file ― Specify a source file for DM24mk3 or CD24 firmware. This
option requires a single value, file, which is the path to the firmware image
file to be loaded.
­­dsp file ― Specify a source file for DM24mk3 DSP code. This option
requires a single value, file, which is the path to the firmware image file to
be loaded.
­­auto­baud S ― can for digitiser baud rate and adjust configuration. If
possible.
­­verbose ― Show most of the digitiser dialog.
­­debug Output some additional debug information from the underlying ―
expect script.
MAN-EAM-0003 116 Issue E - February 2014