IBASE FWA8208 - Manual (Page 8)

7
Jumper Settings on MB967
JP6, JP5, JP4: Bypass LANs & Reboot Setting
JP2: Clear CMOS Contents
Use JP2 to clear the CMOS contents. Note that the ATX-power connector should be disconnected from the board before
clearing CMOS.
JP3 Setting Function
Pin 1-2
Short/Close
d
Normal
Pin 2-3
Short/Close
d
Clear CMOS
JP3: Clear ME RTC Contents
JP3 Setting Function
Pin 1-2
Short/Closed
Normal
Pin 2-3
Short/Closed
Clear ME RTC
JP7: Flash Descriptor Security Override
(ME BIOS Update Jumper)
JP7 Setting Function
Open
Disable
(Default)
Short/Closed Enable to update BIOS
JP6,JP5
JP4
Setting Function
Power OFF Power ON
Power ON,
OS run
software
Normal Bypass Normal Bypass Normal Bypass
JP4 Pin 1-2 & 3-4
Open
JP5,JP6 Pin 1-2
Closed System will bypass
LANs upon the time
out of watchdog
timer.
  
JP4 Pin 1-2 & 3-4
Open
JP5,JP6 Pin 2-3
Closed System LANs bypass
function controlled by
SIO GPIO43&44 or
BIOS Select.
By BIOS Setting
JP4 Pin 1-2 & 3-4
Closed
JP5,JP6 Pin 1-2
Closed System will reboot
upon the time out of
watchdog timer.
  LAN Bypass &
System reboot
JP4 Pin 3-4 Closed
& 1-2 Open
JP5,JP6 Pin 1-2
Closed System will bypass
LANs & reboot upon
the time out of
watchdog timer.
  LAN Normal &
System reboot
Default
Setting