IBASE FWA8206 - Manual (Page 24)

FWA8206 Series User’s Manual
12
When enabled, and after the set time of system inactivity, the hard disk drive will be powered down while all other
devices remain active.
Soft-Off by PWRBTN
This field defines the power-off mode when using an ATX power supply. The Instant Off mode allows powering off
immediately upon pressing the power button. In the Delay 4 Sec mode, the system powers off when the power
button is pressed for more than four seconds or enters the suspend mode when pressed for less than 4 seconds.
CPU THRM-Throttling
When the system enters Doze mode, the CPU clock runs only part of the time. You may select the percent of time
that the clock runs.
Wake-Up by PCI Cards
Enable this field to allow wake up function through a PCI card.
Power On by Ring
This field enables or disables the power on of the system through the modem connected to the serial port or LAN.
Wake Up On LAN
Enable this field to allow wake up function through the onboard LAN.
Resume by Alarm
This field enables or disables the resumption of the system operation. When enabled, the user is allowed to set the
Date and Time.
Reload Global Timer Events
The HDD, FDD, COM, LPT Ports, and PCI PIRQ are I/O events that can prevent the system from entering a power
saving mode or can awaken the system from such a mode. When an I/O device wants to gain the attention of the
operating system, it signals this by causing an IRQ to occur. When the operating system is ready to respond to the
request, it interrupts itself and performs the service.
PNP/PCI Configurations
This option configures the PCI bus system. All PCI bus systems on the system use INT#, thus all installed PCI
cards must be set to this value.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
PNP OS Install No ITEM HELP
Reset Configuration Data Disabled Menu Level
Default is Disabled.
Select Enabled to reset
Extended System
Configuration Data
(ESCD) when you exit
Setup if you have
installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot
Resources Controlled By Auto (ESCD)
IRQ Resources Press Enter
DMA Resources Press Enter
PCI/VGA Palette Snoop Disabled
INT Pin 1 Assignment Auto
INT Pin 2 Assignment Auto
INT Pin 3 Assignment Auto
INT Pin 4 Assignment Auto
INT Pin 5 Assignment Auto
INT Pin 6 Assignment Auto
INT Pin 7 Assignment Auto
INT Pin 8 Assignment Auto
PNP OS Install
Enable the PNP OS Install option if it is supported by the operating system installed. The default value is No.
Reset Configuration Data
This field allows you to determine whether to reset the configuration data or not. The default value is Disabled.
Resources Controlled by