Configuring the hardware – JLCooper Eclipse PX for OS X User Manual
Page 5
Eclipse PX User Manual
Configuring the Hardware!
The unit has an Ethernet Interface that can be configured directly from the front panel of
the unit.!
To configure the Ethernet Interface from the front panel of the unit, do the following:!
1.
Turn unit off or remove power plug.!
2.
Press and hold the Enable and S1 (⟷) buttons.!
3.
Turn unit on or insert power plug.!
4.
Release the buttons.!
5.
The unit will display the firmware version for a few seconds.!
6.
After that, the display shows the first number of the IP address.!
7.
To show or modify the first number of the IP address, press the S1 (⟷)
button.!
8.
To show or modify the second number of the IP address, press the S2 (↕)
button.!
9.
To show or modify the third number of the IP address, press the S3 (⤢)
button.!
10.
To show or modify the last number of the IP address, press the S4 (⤡) button.!
11.
Turn the encoder labelled E1 or FrontDivergence/Width to adjust the IP
address.!
12.
To store the IP address, press the Enable button.!
13.
To load the new IP address, power cycle the unit.!
!
Page 5