TTI TCB-R2000 - Manual (Page 17)

TCB-R2000 English 17
How To Operate the Transceiver
Specifications
7. How to operate the Transceiver
8. Band Selection
9. Trouble Shooting
The same colors are present on the battery and in the fuse box of the car.
* Red : Positive pole (+)
* Black : Negative pole (-)
CE versions of the TCB-R000 which display the CE symbol on
the product label, comply with the essential requirements of
the European Radio and Telecommunication Terminal Directive
1999/5/CE.
This warning symbol indicates that this equipment operates
in non-harmonised frequency bands and/or maybe subject to
licensing conditions in the country of use.
Be sure to check that you have the correct version of this radio
or the correct programming of this radio, to comply with your
national licensing requirements.
2150
This unit can be used without license and charges in; Austria, Belgium, Bulgaria,Cyprus,
Czech, Denmark, Estonia, Finland, France,Germany, Greece, Hungary, Iceland, Ireland, Ita-
ly, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,Portugal,Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland, and U.K.
The power cable is mostly fit for 1.V DC. Be sure the transceiver is off before con-
necting the leads of the power cable to the power supply. It is important to observe the
polarity even if the unit is protected against the accidental inversion :
10. CE Declaration
11. Safety Requirement
Duty cycle 10% 4 Watts @1.8V DC
AM:from 85% to 95%
FM:1.8KHz to +.0KHz
00Hz to 000Hz
50ohms, Unbalanced
Less than -54dBm
AM Full Mod. 1.6A Max.
Dual conversion superheterodyne
Double Conversion 1st 10.695MHz/nd 455KHz
0.7 V for 10dB(S+N)/N in AM Mode
0.7 V for 0dB SINAD in FM Mode
.0W @ 8 Ohm
Less then 8% @ 1KHz
60 dB
60 dB
Less than -57dBm
00 to 500Hz
8 Ohms, round
Adjustable; Threshold less than 1 microvolt
DSS; Less than  microvolt
Channel
Frequency Range
Operating mode
Frequency Control
Frequency Tolerance
Operating Temperature Range
Microphone
Input Voltage
Size
Weight
Antenna Connector
Power Output
Modulation
Frequency Response
Output Impedance
Harmonic Suppression
Current Drain
40 (See the frequency band chart)
6.96 MHz ~ 7.40 MHz
FE (FM), AE (AM)
PLL Synthesizer
0.00%
-10C to + 55C
Plug-in Type
1V/4V DC 10%
190(W) x 165(L) x 58(H) mm
978.5 g
SO-9 type
Receiving System
IF Frequencies
Sensitivity
Audio Output Power
Audio Distortion
Image Rejection
Adjacent Channel Rejection
Conducted Spurious
Frequency Response
Built-in Speaker
Squelch
Receiver
Transmitter
General
12. Specifications
The unit must be wired for the negative ground only.
To avoid damage, do not operate your CB radio without connecting a proper antenna.
TCBR2000 man_reized.indd 17 2011.3.14 5:34:24 PM