Kiddy Click'n move 3 - Manual (Page 22)

EN
22
WArnInG
Before using the pushchair seat make sure that
the 5-point belt system is correctly re-installed,
the buckles match together and work, the belts
are flat routed, the end clips of hip belts and
shoulder belts are placed flat behind rear plate
and the end clip of buckle belt is placed flat un-
der the back slot of seat plate.
4.8 removing/re-installing the cover of pushchair seat
To remove the sun roof open the snap fastener at upper frame of push chair
seat (fig. 23). Open the snap fastener at both sides of sun roof joint (fig. 24; no. 1).
Press both locking buttons (fig. 24; no. 2).
Remove the sun roof by lifting the frame upwards (fig. 24; no. 3).
To remove the Cover of pushchair seat open the snap fastener (fig. 25) and zipper
(fig. 26/27) around the whole frame.
Remove the 5-point belt system as explained under point 4.7.
Now the cover can removed completely.
To re-install the cover, follow the steps for removing the cover in reverse order.
WArnInG
Before using the pushchair seat make sure that
the 5-point belt system is correctly re-installed
as explained under point 4.7 that the cover is
22