Kiddy Click'n move 3 - Manual (Page 26)

EN
26
5.3 Attaching / removing the pram body at/from chassis
WArnInG
Ensure that the parking brake is activated after
unfolding the chassis as described in point 3.1.
If infant carrier adapters were used, they must be removed from the chassis.
The pram body can be used front or rear facing the driving direction.
Insert both plugs of the pram body on the left and right support on the chassis
until they lock into the place and sit tight (fig. 32; no. 1) and the indication at
locking button is “green” (fig. 32; no. 2).
WArnInG
Before using the pram body seat make sure that
both locking buttons indicate “green”. When the
locking buttons indicate “red”, pull these up-
wards, so that “green” will be indicated. test by
pulling upwards whether the pram body is lo-
cked in place and tightly connected to the the
chassis.
WArnInG
the carrying belts shall be left out of the pram
body during use (fig. 33)
26