Kiddy Click'n move 3 - Manual (Page 30)

EN
30 30
7. Care and maintenance
7.1 Care and maintenance of the chassis in general
Periodically check the chassis for loose screws, rivets or worn out or defective
parts. Check the fabric cover and belts for open seams or other defects.
Don’t use the stroller when you noticed a defect. Defective parts have to be chan-
ged or repaired before using the stroller again. If a wheel is squeaking, spray some
liquid silicone lubricant on the axles. Wipe off unnecessary lubricant.
The chassis can be cleaned with a mild cleanser or with a damp cloth. Never use
caustic cleansing agents (e.g. solvents, strong detergents).
7.2 Fabric care in general
All of our fabric meets the highest standards regarding colourfastness against UV
radiation. Nevertheless, all fabric fades when exposed to UV radiation. This is not
due to defective fabric but to normal wear and tear, which is not covered by the
warranty. When the cover (or the chassis) is wet, allow to dry unfolded at room
temperature before storing or using.
The seat cover and the belt pads are machine washable with mild detergent in
delicate cycle. Don’t bleach, spin or tumble dry the cover. Don’t centrifuge, peg
out the cover in wet condition. Don’t heat iron any part of the cover.
The sunroofs are hand washable only. Use a mild detergent and rinse it out with
much warm water. Don’t centrifuge, peg out the cover in wet condition.