Kiddy Click'n move 3 - Manual (Page 27)

EN
27
T
o remove the pram body from the chassis press both locking buttons down-
wards (fig. 34; no.1) so that these indicate “red” and pull the pram body upwards
(fig. 34; no.2).
5.4 Adjustment of the sun roof
The sun roof can be adjusted freely into the desired position by turning the front
bar of the sun roof (fig. 35).
5.5 removing/re-installing the cover of the pram body
To remove the sun roof open the snap fastener at frame of pram body (fig. 36;
no. 1).
Open the snap fastener at both sides of sun roof joint (fig. 36; no. 2).
Press both locking buttons (fig. 37; no. 1).
Remove the sun roof by lifting the frame upwards (fig. 37; no. 2)
To remove the cover of pram body open the snap fastener (fig. 38) and zipper (fig.
39) around the whole frame.
Remove the mattress. Now the cover can removed completely.
To re-install the cover, follow the steps for removing the cover in reverse order.
WArnInG
Before using the pram body make sure that the
cover and the is correctly re-installed and all snap
fastener and zippers are correctly closed the car-
rying belts are place correctly the mattress is in-
side.
27