Laminator Direct EZ-LAM II - Manual (Page 4)

4
Do not leave the laminator power on overnight. Unplug the laminator at
the end of the day.
Unplug the laminator before moving it or when it is not in use for an
extended period of time as a precaution against the possibility of an
internal malfunction that could create a fire hazard.
Do not operate the laminator with a damaged power supply cord or plug,
or after it malfunctions or has been damaged in any manner.
•
Keep the power cord away from hot or wet surfaces.
•
Do not overload electrical outlets beyond their
capacity, as this can result in fire or electrical shock.
This unit is rated at 15 amps and should be the only
item plugged into a 20 amp branch circuit.
•
Adjust only those controls that are specified in these
Operating
Instructions.
Do not attempt to service or repair the laminator yourself. Unplug the
laminator from the electrical outlet and contact an authorized service
representative under any of the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled into the laminator or it has been exposed to
water.
If the laminator has been subjected to excessive jarring through being
dropped or bumped.
If the laminator does not operate normally when following the operating
instructions.
KEEP THE LAMINATOR OUT
OF REACH OF CHILDREN.