LD Systems WS1000(2)(X) - Manual (Page 15)

TIPS FOR IMPROVING PERFORMANCE:
Aim the transmitter directly at the receiver ("line-of-sight" contact between the devices). Do not position the
receiver near metal objects/surfaces or digital devices (CD players, computers, etc.).
Position the receiver so that it is not directly in front of a wall and is at least 1 m above the floor. Cell phones, bi-
directional radio devices, etc. can interfere with the radio link between transmitter and receiver and should not be
operated in the vicinity of the transmitter.
PROBLEM DISPLAY SOLUTION
No sound or volume too low Transmitter: on/off indicator
is off Make certain that the unit is con-
nected correctly.
"Power" indicator is off Make certain that the AC adapter is
plugged into the device correctly and
the other end is plugged in correctly
on the back.
Receiver: RF indicator is on Increase the volume. Increase the
gain setting on the transmitter.
Check the power connections of the
receiver and the connected amplifier
and/or mixer.
Receiver: RF indicator is off.
Transmitter: indicator is on Do not position the receiver near
metal objects. Check whether the
transmission path between trans-
mitter and receiver is unobstructed
("line-of-sight" contact).
Position the transmitter closer to
the receiver. Make certain that the
transmitter and the receiver are
using the same frequency
Transmitter: battery status
indicator is on Replace the batteries
Distortion or unwanted noise Receiver: RF indicator is on Remove possible sources of
interference (CD players, computers,
digital effects units, in-ear monitor-
ing systems, etc.)
Increasing distortion Transmitter: battery status
indicator is on Replace the batteries
Substantial difference in levels in comparison with wired operation with
the same source or when other guitars or microphones are used Adjust the gain setting on the
transmitter and the volume on the
receiver accordingly.
15
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
IT
ALIANO
POLSKI