MBM Corporation 46 - Manual (Page 6)

T10103 Dec 2000
2.3 How to read the display
2.4 Explanation of the menus
MODE On-line
PROOF
The arrow on the left side of the display shows what option
that is currently selected.
Pressing the OK button on the control panel confirms your
selection and the corresponding submenu will appear in the
display.
On the right side of the display, up and/or down arrows
appear if there are more options that could be selected.
These arrows are also displayed when the value of the
selected option can be increased/decreased using the
arrow buttons. Use the up/down buttons on the control
panel for selecting, scrolling or adjustment.
Length: 210mm
Sheets/Set= 1
L=210mm BS=70%
SHEETS PER SET
LENGTH
The ”Main Menu” is displayed with the option ”START” se-
lected when the Model 46 is switched on. The information in
the display shows that the Model 46 is ready to start, it is (in
this case) on-line with the system and the ID number in the
system is one. See table below.
Press the OK button on the control panel to confirm your
selection and the Model 46 will start. If the Model 46 is
installed in a system with a Mailer/Inserter Model 45 and a
Collator Model 306/310, the complete system can be
started from any start button of the units. The ”Main Menu”
will be replaced with the ”Run Mode Menu” when the Model
46/system is started.
START 1
MODE On-line
STOP 00075
PAUSE
Main Menu
Run Mode Menu
Booklet Feeder Model 46 Operator Manual 2-3
**
Model 45 Model 46 Model 306/310
2 1 not installed
3 1 2
3 2 1
1 2 No power
Units in the system
ID number
*
*
**
If placement in PL 46 is changed to ID no.2.
If the power is off in the Model 306/310, it create ”Comm
Error”. Turn on the power in the Model 306/310 and select
OFF-line or ON-line.