MBM Corporation 7228 cutter User Manual
Page 14
Advertising
- 14 -
IDEAL 7228-95
67
Working with programs
- Press
P
.
- Enter desired program number
0
1
...
1
6
.
- Press
➞ proceeds to position.
- Insert the paper and push it with the knocking-up
block (6) to the backgauge.
- Release the cut.
➞ After every cut the backgauge
advances to the next position.
The cutting mechanism is described under No. 3.
Operation.
Press key
¢
and
£
to proceed to the desired
program.
With
the backgauge proceeds to position.
With
the backgauge stops.
General
The red „S“ light is on
➞ specified size not
achieved.
The red „S“ is off
➞ specified size achieved.
key is pressed - Backgauge stops and the
actual size is shown.
Exiting program-mode.
Press
P
.
Advertising