MBM Corporation 7228 cutter - Manual (Page 15)

- 15 -
05-01
07
DIN894
24
4. Maintenance
Danger!
- Maintenance work may only be performed
by trained staff.
- Before replacing the blade or cutting stick
switch off the main switch.
- Disconnect from the mains before
starting any service work or before
removing the cover.
Safety check
According to § 40 VBG 7i a safety check
according to the safety stipulations has to be made
every 5 years by a service team authorised through
our service department. The carrying-out of such a
check has to be attested on the test certificate.
A corresponding test label has to be affixed on the
back of the machine. In Germany such a safety
check is regulated and we recommend it for all
other countries, too.
4.1 Cutting stick
If the last sheet of paper is not completely cut, the
cutting depth must be adjusted.
Setting the cutting depth
- Lower the blade depth adjustment (27) 1/12 using
a spanner.
- Remove spanner.
- Perform cutting test as described below.
If the cutting stick (26) is very worn it must be
turned.
☞
Warning!
Do not cut into the cutting stick too deep as
this shortens the life time of the blade.