MBM Corporation 7228 cutter - Manual (Page 17)

- 17 -
05-02
20
40
21-02
22-01
4.2 Blade replacement
A reduction in the cutting quality indicates that the
blade must be sharpened or a blade change is
necessary.
Danger! Risk of injury!
- The blade is extremely sharp. Do not
remove or transport the blade without
protection.
- Blade replacement work my only be
performed by trained staff.
.
Removing the blade
- Turn the blade depth adjustment (27) to the top
until it stops (spanner in tool set).
- Remove spanner.
- Lower the blade by pressing both cut buttons.
Keep one button pressed and turn off the main
switch.
- The eccentrics (28) are now exposed and should
be turned to position “0“. The special wrench (40)
found in the tool set.
- Turn main switch to position „ I „.
- Wait until the blade is at ghe top.
- Turn main switch to position „ O „.
- Remove the 2 blade screws (29).
- Put the blade changing tool (31) into place and
fasten it to the blade.
- The remaining screws should then be removed.
- Loosen the grips of the blade changing tool (31)
lightly.
- Allow the blade to be taken downwards out of the
machine.
- Place the blade into the blade carrier and screw it
into place.