MBM Corporation 307A (PERF & SCORING UNIT) - Manual (Page 4)

3
2. Preparation before use
View after Perforating unit is mounted
(1) Remove 1st Folding Table to the
direction of arrow.
(3) Install Perforating / Scoring Unit to
the place where 1st Folding Table
was mounted.
(2) Remove the connector of 2nd Folding
Table.
1st Folding Table
Perforating Unit
(4) Set the paper control wire onto the
bail and place the black rubber ring
on the both sides of the wire.
Connector
Pins
Notches
NOTE ：
Fit the notches on the perforating unit to
the pins on the both sides of the folder
Paper Control
Wire
Bail
Black Rubber Rings
(5) Fix the bail on the body of perforating
unit with screws.