Metro Starsys Mobile Power User Manual

Page 8

Advertising
background image

8

Seven (7) multi color LEDs (green, amber) located on the fuel gauge display the charging status of the power supply as
described below:

Keyboard

• A keyboard is situated underneath cart work surface and can be accessed by pulling out keyboard tray.

Keyboard is powered from power supply through USB hub. The maximum size of keyboard the keyboard tray
holds is 16”.

Figure 13: Keyboard

All-In-One Computer/Monitor Mounting

• Depending on the accessory ordered, your monitor can be either mounted on the overbridge or on a post

mounted articulating arm.

• When mounted on the overbridge, a monitor rail and monitor bracket are used. The post mounted articulating arm

is mounted at the left hand rear corner of cart.

• Maximum load that overbridge can carry is 100lbs (45.4kg).

Monitor rail can carry load upto 50lbs (22.7kg).

• Minimum and maximum range of weight the articulating arm can carry is 6lbs (2.7kg) to 26lbs (11.7kg).
• Vesa mounted plate is used to fi x All-In-One computer on overbridge and articulating arm.
• Overbridge is mounted at a single height of 17" (431.8mm) from the cart work surface as shown in Figure 12.
• Monitor rail can be mounted at any two consecutive holes on overbridge which make up the seven different

mounting locations for All-In-One computer/monitors. Refer to Figure 12.

• Powering Up the Monitor:

The Starsys Cart power supply must be turned ON fi rst before turning ON the monitor.

The ON/OFF switch for monitor is located at the back of monitor and can be turned ON/OFF as required.

• Adjusting the Display Position

: To adjust the monitor position to tilt up or down, grab the top and bottom in each

hand and move to the position desired. To adjust the monitor position left or right, grab the sides with each hand
and move to the position desired.

• In order to avoid damaging the display’s screen, do not press the screen with your fi ngers. A soft, clean, lint-free

cloth or a lens brush of camel hair should be used to clean the screen. Never pour or spray any type of liquid onto
the display. Additional information about the operation of the display can be found in the operating manual from
the original manufacturer.

Keyboard

Keyboard Tray

Advertising