Montigo M38DV PRC - Manual (Page 10)

XG0204 04/05 Page 10
Panorama Direct Vented Fireplace
Installation Operation
Lighting Instructions
See Pages 11-12.
Figure 15. Log Installation.
Installing the Logs and Embers
Bottom Logs
The M38DV-PRC is supplied with five (4) fibre logs. The two large
bottom logs (logs "A" and "B") are mounted on the burner grate by
placing them into the slots.
Top Logs
Place logs "C" and "D" into their mating positions on the large logs as
shown in Figure 15 below.
WARnInG: If logs are not placed properly, excessive
sooting will result.
Installing the Ember Material
The ember material is supplied in two packages. Place the material
evenly along the front ember burner tube, next to log 'A'.Refer to
figure 15b
Burner Adjustment
The M38DV-PRC is equipped with an adjustable burner, allowing you
to raise or lower the flames. To adjust the flames, locate the black
knob marked 'Hi-Lo', in the centre of the gas control valve (See Figure
16). The front burners are not adjustable.
 To raise the flame height, turn the black knob (located behind the
lower trim) counterclockwise.
 To lower the flame height, turn clockwise.
Figure 16. 'Hi-Lo' Adjustment on the M38DV-PRC's gas valve.
Note: M38DV-PRC-I models (electronic ignition) do not fea-
ture hi/lo adjustment.
L og ‘ C’
R ear L og ‘A’
Front L og ‘ B ’
L og ‘ D’
Figure 15b. Completed Installation.