NavCom LAND-PAK Rev.F - Manual (Page 94)

LAND-PAK™ User Guide – Rev. F
5-94
Setting Tolerances
Set the tolerance for all possible modes of operation.
Regardless of the user selection, StarFire and RTK-
Extend are automatically set as fall-back modes
unless the user configures the receiver otherwise.
Table 10: Measurement Performance
RTK Positioning – Multi-Frequency <40kms (RMS)
Position (H):
Position (V): + 1cm +0.5ppm
+ 2cm +1ppm
RTK WL Positioning – Multi-Frequency <40kms (RMS)
(see note below)
Position (H):
Position (V): + 5cm +2ppm
+ 10cm +2ppm
RTK Extend (see note below)
Position (H):
Position (V): + 3cm +1ppm
+ 6cm +2ppm
RTK Float
Position (H):
Position (V): + 20cm +3ppm
+ 40cm +3ppm
StarFire
Position (H):
Position (V): + 5cm, GNSS; + 10cm, GPS
+ 10cm, GNSS; + 15cm, GPS
Code Differential GPS <200kms (RMS)
Position (H):
Position (V): + 45cm +3ppm
+ 90cm +3ppm
Velocity (for all DGPS described above)
Velocity: 0.01m/s
Enhanced SBAS (WAAS/EGNOS/MSAS/GAGAN) Position
Accuracy (RMS)
Position (H):
Position (V): + 30cm
+ 60cm
Static Post Processing Mode:
Multi-frequency; L1/L2/L2C/L5/G1/G2
Accuracy (H) + 3mm +0.1ppm