Olson Technology CAN - Manual (Page 24)

025-000570 Rev. X7 www.olsontech.com 24
CONNECTIONS & CONTROLS
POWER SUPPLY
J1 5-Pin DIN Connector to Power Units 1 through 5. Pinout is as follows;
Pin 1 Output DC Voltage (+13 or +17 V
DC
depending on the position of S1 left switch).
Pin 2 Ground
Pin 3 Ground
Pin 4 FAULT. If this input is LOW, D1 will light.
Pin 5 Causes D3-7 to light when pulled high.
Pin 6 22kHz flag. Power supply pulls this LOW if the 22kHz tone is enabled.
Pin 7 Ground
Pin 8 Ground
Pin 9 Ground
J6 AC Input. 90-250 V
AC
, 47-63 Hz. 2.5 Amp Slo-Blo, 5x20mm fuse.
D1 Power indicator. Green when normal.
D2 FAULT Indicator. If any module connector to J1 through J5 pulls pin 4 low, this will be
RED. Otherwise it will be dark.
D3-7 Indicates if a module is connected to this position.
S1-5 The left switch is used to select the LNB voltage (+13V or +17V). The right switch is
used to turn the 22kHz tone ON or OFF.