OnLine Power Power Wave 4 - Manual (Page 65)

6005-145 Rev. A 5-12
- YEAR : 1998 – 2097
- MONTH : 01-12
- DAY : 01 – 31 (internal calendar will correct an error if 31 is entered to a 30 day
month)
- HOUR : 0 – 23
- MINUTE : 0 - 59
- DAY OF THE WEEK : MON, TUE, WED, THU, FRI, SAT, SUN
The value can be increased upward by the UP (↑) key, and can be decreased
downward by the DOWN (↓) key. The value will flash as it is being set. One can
continue to push the UP(↑) or the DOWN (↓) key until the desired value is
displayed. Again, the selection is confirmed by pressing the ENTER(←┘) key.
Thus, the values in the real clock will be changed according to the values entered.
If “EXIT” is selected (blinking instead of pointed by cursor), the screen will go back
to the MENU 5- the PARAMETER SETTING menu.
5.13. Menu 12 – Other Setting Menu
＜ O T H E R S E T T I N G ＞
→ T I T L E :
X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X
P / N : 5 0 3 3 A S ／ N : X X X X X X X X X X I D : X X E X I T
This menu is displayed when the item PARAMETER SET is selected from MENU
1, the SELECT MENU and the correct password is entered. Note that this is a
different password from the password used to enter PARAMETER SETTING
menu, and should only be available to maintenance personnel. This menu can
change the TITLE, P/N, S/N, ID etc. Once this menu is opened, the current value in
the EEPROM will be shown. The cursor (→) can be moved upward by the UP (↑)
key, and can be moved downward by the DOWN (↓) key to the item one wants to
change. The selection is confirmed by pressing the ENTER (←┘) key.