OpenEye VS201 - Manual (Page 37)

30145AB 37
Triggered Action
You can specify which actions the network device should take when motion is detected.
•
Enable Alarm Output – Select this option to activate the alarm output.
•
Send Message by FTP/E-Mail – Select to send an alarm message to the configured
FTP and/or E-Mail when an alarm event occurs.
•
Upload Image by FTP – Select to assign an FTP site. When the alarm is triggered,
event images will be uploaded to the configured FTP site.
•
Upload Image by E-Mail - Select to assign an e-mail address. When the alarm is
triggered, event images will be sent to the configured e-mail address.
Note
Make sure SMTP or FTP configuration has been completed. See the Mail and
FTP section of this manual for further details.
File Name
Enter a file name in the box, ex. image.jpg. The uploaded image’s file name format can be
set in this section. Please select the one that meets your requirements.
•
Add date/time suffix
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
•
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
•
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix will end at the value entered in this box. For example, if the
setting is up to “10,” the file name will start from 00, end at 10, and then start all over
again.
•
Overwrite - The original image on the FTP site will be overwritten by the new
uploaded file with a static filename.