Orion System Modular Service Tool SD - Manual (Page 15)

Modular Service Tool SD
APPENDIX A - SAVE, LOAD, COPY SETPOINTS
15
Restore Setpoints - Network or
Stand-Alone Mode
The Restore Setpoints feature is used to reload a saved setpoints fi le
from one controller back to itself. This could be useful if setpoints or
confi gurations were changed and need to be reset.
You can perform this function on a networked system; however, the
Modular Service Tool needs to be directly connected to the controller
you wish to restore previously saved setpoints to.
From any menu screen, press <BALANCE - TEST> . The Unit Selec-
tion Screen will appear requesting that you enter the unit ID number of
the controller. Enter the network unit ID for the controller you want
to restore setpoints to. Example, 2 for Unit 2. Then press
<ENTER>
.
Once communication is established, *00* at the bottom right of the
screen will go away. After a brief pause, press
<

> to get to the Bal-
ance - Test Screen shown below.
Outputs Force
Para Blocks
Save/Copy/Restore
Scroll down to the ‘Save/Copy/Restore’ option shown above and press
<ENTER> . This will take you to the Save Setpoints Screen shown below.
Save Setpoints
Press Enter To Save
Press <

> four times to access the Restore Setpoints Screen shown
below.
Restore Setpoints
Press Enter to Load
Press <ENTER> . This will reload the setpoints from the saved fi le. You
will receive confi rmation that the setpoints were loaded successfully.
Restoring Previously Saved Setpoints