Paslode IMCT Cordless Framing Nailer - Manual (Page 7)

7
Safety Instructions
12. NEVER DRIVE FASTENERS INTO AREAS WITH
CONCEALED HAZARDS.
Always check the area behind the work surface for
electrical wiring, gas pipes, water pipes, sewer drains or
other potential hazards.
13. ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED
FOOTING WHEN ON LADDERS, PLATFORMS OR
OTHER HIGH LOCATIONS.
14. ALLOW ONLY QUALIFIED PERSONNEL TO OPERATE
THE CORDLESS FRAMING NAILER.
15. PROPERLY STORE FUEL CELL.
16. ALWAYS STORE THE TOOL WITH THE FUEL CELL
AND BATTERY REMOVED.
Store the fuel cell in the case with the Cordless Framing
Nailer.
17. KEEP THE TOOL CLEAN AND WELL MAINTAINED.
A clean tool is less likely to jam or malfunction.
18. KEEP YOUR HANDS CLEAR OF THE WORK AREA
SURFACE.
WARNING
Never over-reach, since
tool recoil may cause a
loss of balance. Always
be aware of edges and
drop-offs when nailing on
rooftops and other high
locations. Keep them in
full view.
WARNING
Always store tool, fuel
cells and battery where
they will not be exposed
to an open flame, sparks
or temperatures above
120° F (49° C).
WARNING
Only persons who have
read and fully understand
all tool operation, safety
and maintenance
instructions should be
allowed to operate the tool.
WARNING
A fastener may exit at an
angle unexpectedly and
cause injury.
Battery Disposal:
The Paslode Cordless batteries contain cadium and must be recycled or disposed of properly. It is illegal in some
areas to place a nickel-cadium battery into the trash or solid waste stream. You may contact your local recycling
center for information on where to return the spent battery or call 1-800-822-8837 for information on Ni-Cd battery
recycling in your area.