Paslode IMCT Cordless Framing Nailer - Manual (Page 8)

8
Battery And Charging System
The Paslode Cordless tool comes with a rechargeable
battery and its own charging system. This charging system
is the only one that will work with all Paslode batteries
(round or oval). It will accept either the round or oval
shaped batteries. The first step in preparing a new tool for
operation is to fully charge the battery. New batteries are
shipped discharged and must be charged prior to first
use. Batteries will take 5 minutes to 2 hours (time will be
dependant on the amount of discharge within the battery) to
recharge.
Important Charging Notes
Charging Instructions:
1. Remove wall mount unit with the orange label from
the tool case and plug into a 120V AC outlet. Set
orange charger on a stable surface and insert the
wall mount unit's plug into the plug receptacle on the
back of the charger(see picture). A green light
indicates power is on and charging system is ready.
2. Remove the battery from tool or case and insert
terminals down into charger. The red light will come
on indicating that the battery is charging and the
green light will go out.
NOTE
If battery is completely discharged the red light and
the green light may flash back and forth for up to
20 minutes. This safety feature slowly recharges
the battery until it is ready to accept the full charging
current. If the red and green lights continue to
flash after 20 minutes, replace the battery.
3. After charging, the red light will go out and the green
light will come on, indicating that the battery is fully
charged. The charger will keep the battery at full
charge until it is removed.
4. Unplug the wall mount unit from the charger and
remove the wall mount unit from the 120V AC outlet.
Charging Times:
First charge (new battery) 2 hours
Discharged Battery 5 minutes to 2 hours
Charging Don'ts:
1. Never charge battery outdoors or in temperatures
below 40°F (5°C).
2. Never allow metal objects to come in contact with
battery terminals.
3. Never puncture or attempt to open battery case or
cells.
4. Never store battery where it will be subjected to
temperatures above 120°F (49°C).
5. Never incinerate battery.
6. Never use a defective battery charger, one that over-
heats and/or smokes when plugged in.
7. Never immerse the battery in water.
Charging System Accessories:
Battery Charger Kit - Part No. 900200
Wall Mount Transformer* - Part No. 900477
Battery Charger Base* - Part No. 900476
Automotive Adapter* - Part No. 900507
* Cannot use with previous (gray in color) charging system
components.
Wall Mount Unit
Charger
Base
THE PASLODE BATTERY CHARGING SYSTEM
Plug
REAR VIEW OF
CHARGER BASE
Plug Receptacle
Battery Disposal:
The Paslode batteries contain cadmium and must be
recycled or disposed of properly. It is illegal in some
areas to place a nickel-cadmium battery into the trash or
solid waste stream. You may contact your local recycling
center for information on where to return the spent battery
or call 1-800-822-8837 for information on Ni-Cd battery
recycling in your area.
WARNING
CHEMICAL/EXPLOSION
HAZARD
Read ALL instructions before
charging or using battery.
Failure to follow ALL
instructions may result in fire,
severe burns, or release of
toxic materials.