Posiflex AURA-6900 - Manual (Page 10)

Part 10
INSTALLING DRIVER
There will be Posiflex Product Information which is specifically created for the
PP-6900. Please find the appropriate subfolder from the non-specific Posiflex
Product Information and please find the information document such as “read
me” or installation guide or application guide and follow the instructions inside.
LAN and Wi-Fi PRINTER SPECIFIC ISSUES
Web Manager for PP-6900L
The default static IP for the PP-6900L is 192.168.192.168 and default listen
port is 9100. User may set his own IP to the same network segment and use
any browser to connect to the printer IP to configure the LAN setup of the PP-
6900L including changing the printer IP for application according to his
network administrator’s request. However, DHCP is not supported.
Reset Button in Pin Hole
As the setup for the PP-6900L/W can be set freely, the changes are not well
registered some troubles could be introduced. Therefore, in PP-6900L/W, there
is a “Reset pin hole” near the LAN connector or Wi-Fi Module. Use something
like a ball pen tip or straightened end of paper clip to push and holding for at
least 5 seconds into this hole will reset the LAN / Wi-Fi setup of the printer
back to the default values at delivery so the user may re-do all setup. The LAN
setup can be viewed in the second paragraph of self-test printout for the PP-
6900L.
LAN POS Printer Manager
This utility can be used to manage multiple PP-6900L’s connection in the
same network under Windows as long as there is no conflicting IP in the
network. This utility can assign to each LAN printer a different device name
for easy recognition. In case of confusion, please check the MAC addresses
listed in this utility against the MAC address label you can find under each
printer.
Any PC connected in the same network can use TCP/IP to use PP-6900L in the
way like a directly connected local printer. So, for direct I/O control by tools
like “HyperTerminal” all commands applicable to the serial or parallel
interface model can work on PP-6900L in the same way, as PP-6900 except
the port must be TCP/IP with the IP address of the printer. Similarly, for
Windows printer driver setup, please “Add Printer” and select for “Local
printer” and select port “TCP/IP” with the printer IP address then use the same
Windows printer driver of PP-6900L.
Posiflex Wi-Fi POS Printer Manager for PP-6900W
When setting the host system by AD-HOC mode; please set the host system IP