Posiflex AURA-6900 - Manual (Page 19)

Part 19
SW3 Switch Position Behavior Table
Switch
position
ON OFF
1 Raster Bitmap Print by line print. Raster Bitmap Print by buffer batch.
2 Print speed 120 mm/s, Enable Disable
3 THAI font process, 3-Pass 1-Pass
4 UPOS Info Auto Write, Enable Disable
5~8 Print Density Adjust
For switch position 3-1, it defines the printing behavior of the printer on
graphic printing. When it is set to ON, the printer prints on each printing
command received immediately. However, the printer may have to engage
brake frequently waiting for next command resulting in trembling. When this
switch is set to OFF, the printer starts printing only when more graphical data
is collected thus performing a much smoother printing operation. For switch
position 3-2, it defines the print speed while process printing; when it is set to
“On”, print speed is enabled in 120 mm/s, when it is set to “Off”, the print
speed is enabled in 200 mm/s or 170 mm/s for DIP Switch Position behavior.
For switch position 3-3, Thailand (THAI) font process is being undertaken and
signifies 3-Pass when it is set to “On”; it signifies “1-Pass” when it is set to
“Off”. For switch position 3-4, UPOS Auto Write is enabled when it is set to
“On”; “Off”, it is disabled. For switch 3~5, 6, 7, 8, Print Density Adjust is
enabled.
Effect of positions 5, 6 , 7 & 8 on Print Density is defined as below:
SW3 Pos.5 OFF ON OFF ON OFF ON OFF ON OFF ON OFF
SW3 Pos.6 OFF OFF ON ON OFF OFF ON ON OFF OFF ON
SW3 Pos.7 OFF OFF OFF OFF ON ON ON ON OFF OFF OFF
SW3 Pos.8 OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON
Print
Density (%)
100 105 110 115 120 125 130 95 90 85 80
Since the qualities of different paper are not alike, please regulate the print
density and printing speed to obtain the satisfaction of printing quality.
SW4 Switch Position Behavior Table
Switch
position
ON OFF
1 Available “Beep” sounds after printing. Disable “Beep” sounds after printing.
2~3 Barcode Height Reduction. (Refer to the table below)
4~5 Line Space Reduction (Refer to the table below)
6~7 Line Feed Reduction (Refer to the table below)
8
DIP switch is disabled
Software Switch SW1 is enabled DIP switch is enabled.
Software Switch SW1 is disabled
SW4-1 switch control the “Beep” sound after printing. Please select “ON” if
this beep sound is required and it will not make any sound after “OFF” is