Progressive Turf Equipment TDR-22 1393176 and Above - Manual (Page 21)

18
6. Lower the wing until the deck swivel mounting points align with the bushings
on the wing deck swivel. Re-install the painted 1-1/4” pins through the
bushings and deck swivel. Secure the pins in place using the 3/8” bolts
previously removed.
7. Install deck stop chains on wing decks
8. When it is safe to do so, fully raise the decks and secure each deck in the
transport position with the corresponding deck locks. Ensure the deck locks
function properly without binding and engage the matching lug on the wing
arm properly.
9. Inspect the front and rear stand-off arms and ensure that they engage the deck
lock mounts properly. If required, lower deck to ground, loosen (3) mounting
bolts on frame, adjust location of stand-off pin accordingly and re-tighten
bolts. Raise deck and re-check stand-off engagement.
10. Remove the TDR Spreader Fixture (526498),
INSTALLING DECK PTO SHAFTS
The three identical PTO shafts are used to drive the mower decks. Each PTO
shaft will have one end designated a tractor end. This end should be hooked up
to the main gear box.
The PTO shafts from the two wing decks must be timed when mounted to the
gear box. See photo below. Mount the one side first with the yoke laying flat. The
opposite side must be mounted with the yoke laying as flat as possible. ie. Timed.
All PTO shafts have a short chain attached on both ends. Find a location to wrap
or hook on short chain. Be sure that when decks are brought into transport
position, the safety chain will not bind or pull PTO shield. Do not forget to install
the PTO spacers to level the driveline. See section on “Hitching to the Tractor”
Input Drive Shaft
Align Yokes
Wing Deck
PTO
Rear Deck Drive Shaft
Align Yokes
Wing Deck
PTO