Progressive Turf Equipment TDR-22 1393176 and Above - Manual (Page 43)

40
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Belt Slippage Lack of Tension
Oily Drive Conditions Increase Tension
Clean up Drive
Rapid Belt Wear Belt Slippage
Belt not in Proper
Groove Increase Tension
Place in Proper Groove
Belt Squeal Belt Slippage Increase Tension
Over-heated Bearings Belt Slippage
Excessive Drive
Tension Increase Tension
Tension Drive Properly
Wing Locks Hard
to Disengage Cylinder not pulling
wing up all the way, or
up too far. Adjust Clevis on end of
Cylinder
Mower Deck will
not Lower
Orifice in Line Throttle
Valve Plugged
With the mower decks
in a secure position.
Remove Line Throttle
Valve, Remove
Obstruction from
Orifice and Reassemble
Excessive wear on
hydraulic cylinder
holes, cylinder pins, or
frame cylinder mounts Hydraulic cylinders are
not able to float freely
while mowing. While mowing, make
sure that the hydraulic
outlet being used is set
to the float position.