Remotec ZRC-100 V1.53 - Manual (Page 47)

47
is completed.
- This action may take
up to 0.5-1 hour
depends on how many
devices are in your
network, and it will
erase all previously
stored device names!
- Please make sure
batteries are full before
proceed!
⇓
Create a Primary Controller
(Transferring Only Network Information to a New Primary Controller)
You can just transfer network information to another remote so that it
will act as a new primary remote and ZRC‐100 will act as a secondary
remote controller. This primary shift is done by following the steps
below.
Step Setup Key LCD Indication
1
Place the two controllers
close to each other.
‐
2
Press and hold cb keys
simultaneously for 3
seconds under the
Home page.
⇓
Scan Devices
to one hr! 5/5
OK
This will take
from several min
Home
Device >
Scene >
Comfort >
OK to Enter
Network Setup
Learning Mode >
Create Pri. >
OK to Enter
Scan Devices >