Remotec ZRC-100 V1.53 - Manual (Page 56)

56
Q Can I include all Z‐Wave devices from the network by ZRC‐100
and no need to click the PROG button for each device?
A Yes! ZRC‐100 provides a useful function which is “Scan Devices”
that allows rediscovering all Z‐Wave devices from the network.
Please refer to user manual with below steps:
i) Assume all Z-Wave devices have been added by gateway.
ii) ZRC-100 should act as a secondary controller [step of C1].
iii) Execute the “Scan Devices” function [step of C2].
ZRC‐100 will rediscover Z‐Wave devices from the network,
discovered devices will be re-assigned to their default
categories (Devices, Comforts and Sensors), and names will
be re-assigned with default naming in ascending order.
- This action may take up to 0.5-1 hour depends on how
many devices are in your network, and it will erase all
previously stored device names!
- Please make sure batteries are full before proceed!
iv) Now, all Z-Wave devices will appear on the Device, Comfort
and Sensor categories. You can rename your device
individually if needed.
Q Can I use 2 or more ZRC‐100 controllers in my house at one time?
A You can use multiple ZRC‐100 around your house by assigning one
remote to be the primary remote and have an additional
secondary controller.
Q What is multi‐channel device?
A The multi‐channel command class used to control one or more
end points in a given device that supports this command class.
There are several kinds of multi‐channel products in the market
such as Z‐Wave wall switch / dimmer and power strip. It is able to
control the end‐point individually.
z
Z‐Wave wall switch / dimmer
Multi-Channel Device
End Point 1 Multi-Channel Device
End Point 2