Rena L-350 - Manual (Page 13)

-11-
at the edge of the peeling mechanism. If the sensor does not see the label, any
attempt to run the labeler will result in failure to feed the media. A flashing light
indicates labeler is out of labels.
7. Depressing the LABEL switch [Figure 10E] will activate label-affixing circuitry in the
labeler. The yellow indicator light should be on. Depressing the FEED switch [Figure
10F] will activate feeding mechanism and labeling process.
8. Adjust speed to desired setting by turning the speed control knob [Figure 10D]. Add
envelopes to the labeler as needed. To stop the labeler, depress the FEED switch.
9. DO NOT FORGET TO REMOVE ENVELOPE FROM BETWEEN EXIT ROLLERS
PRIOR TO ACTIVATING LABELER.
10. If the labeler runs out of envelopes, it will automatically stop after a few seconds. The
green light in the FEED switch will start flashing indicating an OUT-OF-ENVELOPES
condition. Depress FEED switch to reset labeler. Load envelops between the guides
and depress switch to start the labeling process.
11. If there are no more labels, or, if two or more consecutive labels are missing, the
labeler will stop and the yellow LABEL OUT indicator light will flash.
12. The counter (H. Fig. 8) will advance one count with every label placed on an envelope.
It will only count when LABEL ON switch is activated. Maximum count is 99,999. To
reset the counter to 0, depress the COUNTER RESET switch (1, Fig. 8).
ZIP-SORT
With the ZIP-SORT switch ON [Figure 10C], the machine will stop every time a missing
label is detected. To activate this feature, manually remove leader label from each zip
code or carrier route prior to loading labels onto the labeler and slide the ZIP-SORT switch
to the ON position. Operate the labeler in the usual manner.
When a missing label is detected, the labeler will stop and the LABEL OUT indicator light
will flash. Depress the FEED switch to reset the machine, and, using the LABEL
ADVANCE knob, bring the next label to the peeling mechanism. Separate the labeled
pieces. Depress the FEED switch again to resume labeling.
WARNING
NEVER LEAVE THE L-350 WITH POWER ON FOR A
PROLONGED PERIOD. DAMAGE TO INTERNAL
COMPONENTS MAY RESULT!