Rena L-350 - Manual (Page 3)

-1-
SPECIFICATIONS
L-350 TABBER/LABELER/STAMP AFFIXER
DIMENSIONS: 16 1 /
2
" W x 19" H x 18" L
SPEED – TABBER: Variable from 5,000 - 20,000 per hour ( Tri-folded 60 lb.
Offset Stock)
SPEED – LABLER Variable from 5,000 - 20,000 per hour ( No.10 envelopes )
Postcards 20,000 per hour
9" x 12" flats 12,000 per hour
MEDIA SIZE: Length – 3 5/8” min., 18" max.
Width - 5" min., 16" max.
MEDIA THICKNESS: Label: single 20lb sheet min. - up to 5 /
16
" max.
Tab: folded 20lb piece min. - up to 1 /
8
” max.
TAB SIZE: Length - ** 5 /
8
" to 1 1 /
2
", Width - 1 /
2
" to 2"
TAB TYPES Paper, *Clear, *Translucent
* must have engineered backing (black area below tab)
LABEL SIZE: Length - ** 5 /
8
" min., 15" max, Width - 1 /
2
" min., 6 1 /
2
" max.
Automatically compensates for most color labels and
backing
STAMP: Can apply stamps to pieces up to 9.5” in length.
FEEDER: Top-load, bottom-feed for continuous operation.
HOPPER CAPACITY: Postcards 800
No.10 envelopes 250
9"x12"flats 250
ZIP SORT: Switch selectable electronic sensor (labeler only)
COUNTER: Resettable 5-digit LCD
ELECTRICAL: 110 VAC /60 Hz 2 Amp (220 VAC / 50 Hz available)
SHIPPING WEIGHT: 70 Ibs /32 kg
NOTE: There are two types of tabs/labels used commercially. One is designed for hand,
and the other is for machine application. Use tabs/labels designed ONLY for machine
application with the Tabber/Labeler. Avoid using tabs/labels with little or no contrast
between tab/label and backing. Less than 2 clicks on the tab/label sensitivity adjustment
will not allow unit to run properly. Doubles and misfeeds are a symptom of the wrong label
being used.
** Assuming tab/label has a 1/8” gap between tabs/labels. If gap is larger this increase will increase the
minimum label length. Example: ¼” gap = ¾” min label/tab length.