Rena T-350 - Manual (Page 21)

OPERATING THE TABBER
Shaft
6. Thread the tabs under the small shaft at the top of the tab drive assembly. Pull
about 18 inches of tab stock out the front of the tab drive assembly.
Verify Proper Tab Stock
Orientation:
The tabs must be located on
the front side of the stock, as
shown. If the tabs are located
on the back of the stock, then
you must remove the tabs
from the unit, remove the tab
box from the tray and turn it
around 180 degrees. Re-start
process from step 1.
7. Thread the tabs under the peel bar and out the
other side of the tab drive assembly, as shown.
Note: Red tab stock shown to improve visibility.
8. Position the tab stock so the hole, in center of the first
tab, is aligned with the red dots at the inside edges of
the tab drive assembly.
T-350 Operations Rev. 3/23/2009 21